Shooting Pro-Shot Trainer is designed to simulate the entire shot process through to shot execution without the use of an arrow

Clearly and accurately feel appropriate muscles, gain body awareness while experiencing accurate sight pictures, practice release, and follow through with mitigated post-shot response

Real sound clicker adds to an accurate recreation of actual shots within the archer's true clicker zone

Installs using the risers ATA standard 5/16 x 24 Berger/plunger hole (use both Berger hole and rest mount hole if equipped on riser)

Adjust the 1/4-20 screw of the cantilever arm and pipe clamp to center the simulated arrow shaft within the sight window or slightly outside the center as you would set plunger depth

Draw out the simulated arrow shaft to connect to your bowstring at brace height

Remove nock set screw and attach to the bowstring

The simulated arrow shaft should be perpendicular to the string

Adjust nock height until perpendicular or slightly nock high (the use of soft tie on nock points would be recommended to maintain nock height)

Adjustment pressure screw has a max turns  6 in

Pneumatic setting should correspond to limb weight

0-1 full turn in = 25lbs @ 27"
1-2 full turns in = 23-30 lbs @ 27"
2-3 turns in = 30-35 lbs @ 27"
3-4 turns in = 35-40 lbs @ 27"
4-6 turns in = 45 lbs @ 27"

Settings are only guidelines Do Not exceed 50 lbs of weight when using the trainer.

Notes: Too much pneumatic pressure the bow will vibrate and the piston will stop short, Too little pressure and piston may impact the trainer base or bow riser